 |
CGSIMMSTICK1 connection information |
The power select jumper nearest to the USB jack (left one if you hold the board so that you can read the silk-screen text) connects 5V USB to the 3.3V regulator to power the microcontroller.
The right jumper connects the 5V line on the 30-pin row to the 3.3V regulator so that the solderless breadboard can power the microcontroller.
Both in place puts 5V USB onto the J1 30-pin connector.
5 is audio out - square pad is signal, round is ground.
J4 is video select. Open is VGA. insert a wire link for composite.
J3 with a header in place is firmware reload.
J8 and J9 are PIC32 programming headers.
D1 – Green “Firmware” LED.
D2 – Blue SD card access LED.
Purchase a CGMMSTICK1
Download of Maximite Integrated Development Environment: MMIDE
No comments:
Post a Comment